(2) Basic casing power switch control cable kit
Follow the connectors list below for installation (see figure below)
4-5 Connection of Fan Power Cable
This chassis has 1 x 12cm silent cooling fan at the front and 1 x 12cm silent fan at the rear. There
are internal connectors that connect the front and rear fans making it into a single 3-pin power
connector.
Required Tools: None
4-5.1 Insert the 3-pin connector into the system fan power connector on
the motherboard.
4-6 Installation of 5.25” Front Device Bay
4-6-1
Open the front panel door and side panel, remove the plastic bezel and aluminum EMI plate
through the inside of the chassis.
4-6-2
Slide-in the 5.25” device through the front panel to align it with the front panel bezels.
4-6-3
Secure the 5.25” device with the internal latch. Refer to the figure for installation procedure.
4-6-4
Installation complete.
Connector Color
Power LED Green(+) / Wite(-)
Power SW Orange(+) / White(-)
Different Motherboards have different installation areas, specifications, screw
holes and connectors. Please read the motherboard user manual supplied by the
motherboard manufacturer.
4-6.1 4-6.2 4-6.3 4-6.4
4-7 Installation of 3.5” Front Device Bay
The Installation of the 3.5” front device is the same as the installation of the 5.25” front devices.
Please refer to step 4-6.
Required parts: none
4-8 Installation of 3.5” Internal Device Bay
This chassis provides built-in bays to accommodate up to 5 hard disc drives (after removal of the
tool enclosure). The HDD requires securing runners, which can be found in the tool enclosure.
4-8-1 Place the runners on both sides of the HDD. Slide the HDD into the hard disk bay evenly.
4-8-2 For installations of the fourth and fifth HDDs, loosen the tool enclosure, and then install the
HDD in accordance with step 4-8-1.
4-8.1 4-8.2
LOCK
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais