Gigabyte GA-EX38-DQ6 Manual

A. Teaming Part a. Create Teaming Flow (i) From the start up menu, left click the icon in ProgramsÆRealtek Teaming and VLAN Æ Realtek Teaming and VLAN

(vii)Select the virtual Adapter and right-click to select “Properties” (viii) The below figure is showed the properties. There, click the “Configure

(ix) Select Advanced Page and Click Vlan ID properties to setup the value.

b. Remove Vlan Flow (i) If without closing the user interface, directly click remove button. (The selected adapters don’t care) If closing the user i

(ii) If the Vlan removed completely, the Dialog shows “Remove VLAN Virtual Adapter Finnished” and click OK.

(iii) Teaming needs to set three parts 1. select adapters (at least two adpaters) 2. select teaming mode There are three teaming modes for us

3. after selecting teaming adapter and teaming mode, click teaming button (iv) If the Teaming created completely, the Dialog will show “Create Virtu

(vi) Network Component has a new Virtual Adapter For Teaming b. Teaming Notes (i) The gigabit switch prefer supporting teaming function (likely F

FEC/GEC and the mode of the teaming switch is LACP, the teaming switch will send LACP packets to the teaming server and wait the response form the tea

(ii) If the Vlan removed completely, the Dialog shows “Remove Teaming Virtual Adapter Finnished” and click OK.

B. Vlan Part a. Create Vlan Flow (i) From the start up menu, left click the icon in ProgramsÆRealtek Teaming and VLAN Æ Realtek Teaming and VLAN Utili

(iii) Click to select one adapter for Vlan (one adapter selected) (iv) Click the Vlan button and start to create Vlan

(v) If the Vlan created completely, the Dialog will show “Create Virtual Adapter For Vlan Complete” and click OK. (vi) Network Component has a new V